Page 1 of 1

[HELP] adding multipule textures to a custom obj

Posted: March 20th, 2015, 3:35 pm
by sean duncan
the obj model i made is a sky skraper. when i load it into sandbox the only texture that it will apply to the model is the sides/windows of the massive structure. it will not add the texture i made for the ground floor/shop windows/doors at the base of the *censored*. anyway I've looked everywhere to help me fix this problem but i can't find a solution. the structure looks how i want it to in blender but in P.A. sandbox it runs the sides texture down to the base(refer to attachment CAM00018 to see my problem. any feed back with advice or any kind of relevancy to my problem would be much appreciated. p.s. i spelled sky skraper wrong because it kept censoring it.

Re: [HELP] adding multipule textures to a custom obj

Posted: March 20th, 2015, 6:36 pm
by Wind Astella
http://windastellaworld.blogspot.com/20 ... s.html?m=1
you can the solution in my old tutorial. the trick is you'll need yo separate mesh with their own texture and config as such. that is how pas handle multiple textures.

Re: [HELP] adding multipule textures to a custom obj

Posted: March 20th, 2015, 6:45 pm
by sean duncan
Thanx very much for the reply i will check out the tutorial an let u knoe if ifixed prob. thanks again

Re: [HELP] adding multipule textures to a custom obj

Posted: March 20th, 2015, 7:14 pm
by sean duncan
okay so can i just ignore the whole tree[D] part?