Platinum Arts Sandbox - Free 3D Game Maker Forum

I've been having some water difficulties. There isn't anything wrong with it, but I just need help.

I can put water in a regular hole that's flat on all sides fine. But I'm having trouble doing it in rough ground. Especially when it's deep, because it will only fill a few layers.

If I try putting it in a regular hole, then making the ground rough, it deletes the water.

Have you checked out this video?
http://www.youtube.com/watch?v=g44Ww2bg2_E

I go over how to fill in areas with water quickly and easily. Take care.
-mike

Or you can make a small hole (one cube length) and make it go down as deep as possible. Then you go to the bottom (on edit) and fill it with water. Be sure that when filling water, you go all the way to the opposite corner (on the surface). Am I making sense? Just wondering.

Try clicking on the top right corner and dragging downwards, to the bottom left corner. Then type in the console "editmat water" without the quotes.


press ~ to open the console

hope this helps