slow down to a walk and smell the roses too.
So off I went looking at the cfg files till I found the command to slow your default traveling speed down.
Before editing a map's cfg file, first make a backup copy. That way you can replace your edited file if you
make a mistake and mess up your map's cfg file.
I would recommed downloading and installing notepad + + for editing your config files. This program is also
recommended by the developers of Sandbox.
http://notepad-plus.sourceforge.net/uk/site.htm
The maps cfg files are located in the packages/base folder.
Choose the map cfg file you want to edit.
Scoll to near the bottom till you see the word "//aliases " without the quotation marks.
Add the below text as shown below:
//aliases
"on_start" = [
movespeed 10
]
You can change the movespeed to a higher number, I set it for a slow walk. The higher the number the faster
you will walk.
Now this will also slow your editing mode travel speed down.
Press the escape key and click on editing GUI
Set your floatspeed at about 600. This will increase your travel speed for editing only. (note you have to do
this each time for floatspeed when you reopen your map)
You can now enjoy walking around the map at your speed and also keep your editing travel speed for building
the map...
