Page 1 of 1
I know, I have a lot of problems (:
Posted: August 18th, 2009, 12:46 pm
by Mama's Boy
My sandbox has just started acting up! First, it would slow down a lot when I was near water, so I turned off some water shaders. Then it stopped loading certain maps. I tried a lot of other things, but it wouldn't help at all, so I tried to reinstall the entire program. (I'm using a mac, and I don't think there's an official way to uninstall/reinstall.) When I reinstall everything again, I still have the same problems, only this time, I have only one playermodel, which is an un-animated rc. Is there something I can do to set everything back to normal. I'm really upset
because I love using sandbox, and the map I've been working on for months is one of the ones that won't load. Thanks, I think this forum is awesome!
Re: I know, I have a lot of problems (:
Posted: August 18th, 2009, 3:40 pm
by bobofoxy123
lol seems u need a better amount of ram
Re: I know, I have a lot of problems (:
Posted: August 18th, 2009, 3:45 pm
by Mama's Boy
I don't think so. Just recently, the water is back to normal and everything is fine! My fps is, and has always been 200. I just hope that 2.4 comes out soon. I don't know how I'll live without my normal sandbox
Re: I know, I have a lot of problems (:
Posted: August 18th, 2009, 8:28 pm
by Mama's Boy
For the most part, everything's back to normal. There are 3 problems.
1. Some maps that I have created or downloaded before aren't loading anymore. Instead, I get a blank map, and it says, "map requires a newer version of sandbox: <mapname and path>."
2. My camera is going through walls during gameplay mode.
3. I can't switch playermodels!
Re: I know, I have a lot of problems (:
Posted: August 19th, 2009, 8:32 am
by Mike
If you are using the dev version of Sandbox you can't use them in 2.3 If you downloaded Ahab's train map and it isn't working, that only works in the Dev version. Take care.
-mike