Page 1 of 1
Forced Shadows - negative RGB not enough?
Posted: June 21st, 2009, 10:01 pm
by CollegeforKids
I'm creating a cave carved into a mountain on my map. The cave just isn't dark enough for how deep inside the mountain it is, so I'm trying to make a shadowed area...The wiki mentions trying making the rgb values negative. I have tried this (all the way from -50 all the way to -1000.) The thing is that when in edit mode, the shadow appears. Out of edit mode, even after recalculating, the shadow does not appear. Is this actually possible? Just curious...
Re: Forced Shadows - negative RGB not enough?
Posted: June 22nd, 2009, 12:14 am
by Joe Staff
make sure brightmode or whatever is off [default key: L when in Edit Mode]
Re: Forced Shadows - negative RGB not enough?
Posted: June 22nd, 2009, 3:38 am
by Hirato
regardless of the shadow light's strength, the brightness will NEVER under ANY circumstance go below the values for /ambient, so give that a boost or a decrease and see if it helps
Re: Forced Shadows - negative RGB not enough?
Posted: June 22nd, 2009, 11:28 am
by CollegeforKids
Thanks, Hirato, that was the issue