Page 1 of 2
My first model.
Posted: November 13th, 2010, 11:35 am
by klimyriad
Well i am very proud of this and it only took me 10 minutes to make as well.
Here you go
http://www.sendspace.com/file/53l48w
Re: My first model.
Posted: November 13th, 2010, 1:02 pm
by InHumanUnit
A tower, eh? Nice.
Re: My first model.
Posted: November 13th, 2010, 3:05 pm
by chocolatepie33
that's a pretty good model, what'd you use to make it?
Now if only we had specialized model collisions... then we could be on the tower, not over it.
Re: My first model.
Posted: November 13th, 2010, 5:39 pm
by klimyriad
I use wings 3d for it i am trying to get it so you stand in it.
Re: My first model.
Posted: November 13th, 2010, 5:44 pm
by chocolatepie33
yeah, the problem is using mdlcollide 0 ( or 1, not sure which is which) would just make you fall through it.
Re: My first model.
Posted: November 13th, 2010, 5:45 pm
by klimyriad
Do i put that in the obj.cfg file.
Re: My first model.
Posted: November 13th, 2010, 5:48 pm
by chocolatepie33
I think so... I don't know completely about it because it's an obj model, not md3
Re: My first model.
Posted: November 13th, 2010, 5:48 pm
by klimyriad
I see thanks i do that now.
Re: My first model.
Posted: November 13th, 2010, 5:52 pm
by klimyriad
It is mdlcollide 0
Re: My first model.
Posted: November 13th, 2010, 5:53 pm
by chocolatepie33
alright. I guess you could use clip, but that'd be a pain to get each little corner and stuff...